VITO Pro power VIMPDP1500 Manual De Instrucciones página 30

Idiomas disponibles

Idiomas disponibles

The hammer has been designed to perform drilling, boring
and chiselling operations in concrete, brick, stone and
asphalt.
When you work with the rotary hammer, you should take
into consideration some cares and procedures of use:
▪ When the drill bit jams, switch off the rotary hammer
immediately. Avoid high reaction torques that cause
kickback;
▪ Always work with the auxiliary handle fitted and hold the
hammer with both hands. Loss of control of the rotary
hammer can cause serious injury;
▪ Do not apply too much pressure on the rotary hammer
against the workpiece/object. If the speed drops
abruptly, reduce the pressure on the hammer
immediately;
▪ Never put down the rotary hammer before the drill bit,
pointed or flat chisel, is completely stopped;
▪ Wear
hearing
protection
hammers. Exposure to noise can cause hearing loss;
▪ Work in such a way that the power cord is always behind
the rotary hammer during operation;
▪ Switch off the rotary hammer immediately if any of the
following problems occur:
- Sparks in the brushes and smoke appearance;
- Grease leakage through the ventilation slots;
- Damage om the rotary hammer housing;
- Damage to the "ON/OFF" switch;
- If you sense smoke or burning smell.
Never change the operating mode while the motor is
running, otherwise unexpected accidents may occur.
Change the operating mode when the motor is completely
stopped.
1. Set the arrow (▲) on the selector switch (7) to position (
);
2. Fit the drill bit into the chuck hole (2);
3. Press the "ON/OFF" switch (8) and touch the drill bit
against the surface to be drilled;
4. Press the rotary hammer in the direction of the surface
to be drilled. It is not necessary to apply too much
pressure;
5. To switch off the rotary hammer, release the "ON/OFF"
switch.
while
operating
rotary
Never change the operating mode while the motor is
running, otherwise unexpected accidents may occur.
Change the operating mode when the motor is completely
stopped.
1. Set the arrow (▲) on the selector switch (7) to position (
);
2. Fit the accessory into the chuck hole (2);
3. If using a chisel, adjust the position to the required
direction;
4. Press the "ON/OFF" switch (8) and touch the drill bit to
the surface to be drilled/chiselled;
5. Press the hammer in the direction of the surface to be
drilled/chiselled. It is not necessary to apply too much
pressure;
6. To switch off the rotary hammer, release the "ON/OFF"
switch.
Never use pointed or flat chisels with the rotary
hammer in "Hammer Drilling" mode (
are used in the "Demolition" position ( ).
Use this function to drill in wood, plastic or metal.
To adjust the position of the chisel, place the arrow (▲) of
the mode selector switch (7) into position (
chuck sleeve (2) until the chisel is in the desired position.
When you turn the mode selector switch to select the
operation mode, the chisel is locked.
The rotary hammer is equipped with an active vibration
reduction system, which cuts vibration without reducing
performance. This system significantly reduces the
exposure level over the total working period, protecting the
user from the effects of vibration.
). Ensure they
) and turn the
loading