Gima Cardio B Manual De Uso Y Mantenimiento página 22

On-screen display:
1. "16: 14: 32": Current time.
2. "X1": ECG waveform gain.
"X1/2": Waveform scaled with half of the basic gain;
"X1": Waveform scaled with basic gain;
"X2": Waveform scaled with twice of the basic gain
"X3": Waveform scaled with three times of the
basic gain
3. " ": Heart beat mark. Its flashes are
synchronized with heart beats.
4. " ": Indicating that ECG filter mode is
"Enhanced"; Refer to section 3.6.5 for filter setting.
5. " ": Status of battery power
6. " ": ECG waveform
7. " ": Ruler for 1mV amplitude
8. " ": Compact compression of scaled waveform.
2. When the compact compression of scaled waveform reaches to the end,
it means the measurement finishes, then the device steps into data analysis
phase which is followed by measurement results display as shown in Figure 3-5.
" Return": return to main menu screen directly and the current measurement
result and measuring value won't be saved.
" Save": save the current measurement result and measuring value.
3. In the measurement result screen, the current measurement data will be saved
in this device automatically without any operation in 6 seconds or directly press
the " Save" key to save the data, as shown in Figure 3-6. The device will return
to the main screen automatically after the data is saved.
3.3.2 Continuous Measurement
1. After choosing the continuous measuring method as described in Chapter 3.2.2,
press the " Measure" to perform continuous ECG measurement automatically as
shown in Figure 3-8. The difference between the continuous and quick measurement
is described below:
" Exit ": the prompt information of operation on the screen. Press the "
Return" button to end the ECG measurement and return to the main screen.
If the time of continuous measurement is over 30 seconds, this data will be
saved automatically.
"HR=59": indicates the real-time heart rate.
2. If there is no operation after the continuous measurement has been carried out
for 3 minutes, the unit will adopt power-saving mode automatically (the screen
will darken), but the measurement won't be interrupted. Once you press any
button or the alarm event occurs, the system will exit power-saving mode, and
the screen resume to normal brightness.
Notes: 1) Figure 3-5 shows a regular ECG waveform measurement result,
this device can provide 17 types measurement results, refer to Table 3-1(Section
3.4.3) for details.
2) During measurement, if the measured part and metal electrodes loosely contact,
the device will prompt "Contact?", as shown in Figure 3-9. If there isn't signal, it
will prompt "No signal". The user can press "
measurement.
ENGLISH
Return" button to exit from the
Figure 3-4 ECG Measuring Screen
Figure 3-5 Measurement Result Screen
Figure 3-6 Data Saving
22
Figure 3-8
Figure 3-9