Idiomas disponibles
Idiomas disponibles
Maintenance
CARTRIDGE REPLACEMENT
- Turn off the water supply to the faucet .
- Unscrew the handle lever (1) . Loosen the set screw (2) with
the hex key and remove the handle body (3) .
- Gently unscrew the decorative cap (4) and retaining nut (5) .
- Pull the cartridge (6) out of the faucet body (7) and replace
it with a new ceramic cartridge . Ensure new cartridge is
seated properly with the locating pins in appropriate place .
- Secure the cartridge in place using the retaining nut (5) .
- Gently tighten the retaining nut (5) using a wrench . Do not
overtighten .
- Reinstall the decorative cap (4) . Slide the handle body (3)
back onto the cartridge and make sure it rotates freely .
Secure the handle body (3) in place using the set screw (2)
and reinstall the handle lever (1) .
- Turn the water supply to the faucet back on .
- Operate the faucet to make sure everything works
correctly and check for leaks .
Care and Cleaning
Your sink is manufactured with the highest grade stainless steel and will provide you many years of enjoyment with the proper care .
SINK
Do
- After use, always rinse your sink with tap water to dilute and remove deposits .
- Towel dry after use whenever possible to prevent water spots . Should water spots
occur, clean with a mild solution of vinegar and water followed by a thorough rinse .
- Use liquid soap, a general household cleaner, or a weak solution of vinegar and water
for regular cleaning .
- Only use plastic scouring pads recommended for use in stainless steel sinks, and
only use them in the bowl of the sink. Scrub in the direction of the satin finish lines.
Do not
- Do not allow any food, detergent, soap or grease to dry or sit for extended periods of
time on the surface of the sink .
- Never use abrasive cleaning products, as they will dull and scratch the finish.
- Do not use scouring pads on the deck, as they will dull the finish.
- Never use steel wool pads, as they will leave iron particles on the sink, which will cause
corrosion .
- Never leave steel or cast iron pans in your sink for extended periods of time, as this can
cause corrosion .
- Never use chlorine-based cleaners in your new sink, they could lead to rust spots and
discolouration . If you must use them, rinse sink thoroughly with fresh water immediately
after use . If any chemicals or glue make contact with the sink during installation, wipe
clean and rinse thoroughly with fresh water .
QL102
Cartridge (6)
Faucet
body (7)
CABINET
Do
- Remove dust and dry dirt with a soft, damp cloth .
- Clean grease, oil, paint and ink stains with isopropyl (rubbing alcohol) . Immediately
rinse with water after
stain removal .
Do not
- Do not allow your cabinet surface to come into contact with products such as acetone
(nail polish remover), nail polish, dry cleaning solution, lacquer thinners, gasoline, pine
oil, etc .
- Use caution when using sharp instruments that may fall and scratch the surface .
10
Retaining Nut (5)
Handle
Decorative
Lever (1)
Cap (4)
O-Ring (8)
Set Screw (2)
Handle
Body (3)
