Idiomas disponibles
Idiomas disponibles
3. How to use
Reset
1
2
+
Press + hold!
3
Reset completed
ECO mode
Power limit
Unit provides no output
Reset to factory setting
All factory settings can be recalled:
• Press
and
simultaneously. The display now counts backwards from "10" to
"00" in second intervals. The appliance is reset at value "00" - if you stop pressing
the keys earlier, you will cancel the process.
How to save energy
Set the exact temperature you need on the appliance and open the hot water tap.
Once you feel that the water is too hot, do not add any cold water and, instead, enter
a lower temperature on the appliance. If you were to add cold water, the water already
heated would cool down again and valuable energy would be wasted. Moreover, the
cold water added in the tap is not covered by the control range of the electronic cir-
cuitry, with the result that temperature constancy is no longer guaranteed.
ECO mode
The symbol
shows that the appliance works in an energy saving mode (i.e. the
momentary energy consumption is subject to the selected temperature and to the flow
rate in the energy saving mode.
Power limit
If the full output of the instantaneous water heater does not suffice to heat the tapped
quantity of water, this will be indicated by
open ing several taps at once). When you reduce the hot water flow rate,
lighting because the output of the appliance is sufficient to reach the set temperature
again.
Top-up heating
When operating with preheated water (e.g. with solar systems), you must ensure that
the maximum inlet temperature is not exceed.
If the inlet temperature exceeds the setpoint, the icon
cates that the heating power is switched off.
13
on the LCD (e.g. in winter time, when
on the digital display indi-
CLAGE
EN
stops
