Petsafe PDT19-14596 Manual De Funcionamiento página 8

OPERATING GUIDE
STEP 1
Prepare the Handheld Remote
Charge the Handheld Remote
1. Lift the rubber cover protecting the Handheld Remote
Charging Jack.
2. Connect one of the charger connectors to the Handheld
Remote Charging Jack (1A).
3. Plug the charger into a standard wall outlet.
4. Charge the Handheld Remote for 5 hours for the fi rst charge.
Recharges take only 3-4 hours. Note: The Battery Indicator will
scroll while charging and will become solid when fully charged.
5. When charging is completed replace the rubber cover. Note:
Approximate battery life between charges is 40 to 60 hours,
depending on frequency of use.
Turning On the Handheld Remote
Power up the Handheld Remote by pressing any button. You will see the Digital Display turn
on when you press any button.
Handheld Remote Digital Display
The Digital Display stays on for 1 minute after a button is pressed. After 1 minute with no buttons
pressed, the Digital Display shuts off and the Handheld Remote goes into battery conservation
mode. Pressing any button will cause the Digitial Display to turn back on. The various display
symbols are explained below.
Numeric readout
Dog 1/ Dog 2
Tone or Spray
Tone Only
Battery Indicator
Note: Factory preset is for Dog 1 mode, you will not see the Dog 2 symbol unless the unit is
programmed for Dog 2 (see 2-Dog System on page 15).
8
Displays the Spray Level for Dog 1 or Dog 2.
The symbol displayed is the active dog Receiver
Collar. See 2-Dog System on page 15.
When pressing the Tone or Spray Button the
Dog 1 or Dog 2 symbol will appear in bold or
emphasised.
When pressing the Tone Button for Dog 1 or Dog
2 the number nought appears.
The battery indicator provides constant awareness
of your battery's power level. See Battery Indicator
for more detailed information.
www.petsafe.net
1A