Practical Applications - Hitachi Koki C 10FCH2 Instrucciones De Seguridad Y Manual De Instrucciones

ø12 Hole
Laser line
Move
Groove
Laser marker
Laser line
Left
Right
Hex socket
bolt
Hex bar wrench
(Accessories)
Fig. 17
(3) After adjusting the position of the laser line, draw a right-angle ink line on
the workpiece and align the ink line with the laser line. When aligning the
ink line, slide the workpiece little by little and secure it by vise at a position
where the laser line overlaps with the ink line. Work on the grooving again
and check the position of the laser line. If you wish to change the laser
line's position, make adjustments again following the steps from (1) to (3).
Marking
(pre-marked)
Fig. 18
NOTE:
Check and make sure on a periodic basis if the position of the laser
line is in order. As regards the checking method, draw a right-angle
ink line on the workpiece with the height of about 1-1/2 in. (38mm)
and the width of 3-1/2 in. (89mm), and check that the laser line is
in line with the ink line [The deviation between the ink line and the
laser line should be less than the ink line width (0.5mm)]. (Fig. 18)

PRACTICAL APPLICATIONS

WARNING:
∗ To avoid personal injury, never remove or place a workpiece on
the table while the tool is being operated.
∗ Never place your limbs inside of the line next to warning sign
while the tool is being operated. This may cause hazardous
conditions (see Fig. 19).
4mm Hex.
bar wrench
Turn
Laser holder
Gear case
Laser line
Warning
Line
sign
Fig. 19
1. Switch operation
Pull the trigger to turn on the switch, release it to shut it off .
After releasing the trigger, make sure the trigger has gone all the way
back and the switch is turned off .
Trigger switch Hole
Fig. 20
WARNING:
This will ensure that the power tool cannot be turned on accidentally
or by someone (especially a child) who is not qualifi ed to use the
power tool.
To prevent unauthorized operation of this tool, insert a padlock to
the hole in the switch trigger to disable the use of the switch.
2. Using the Vise Assembly (Standard accessory)
(1) The vise assembly can be mounted on either the left fence {Fence (B)}
or the right fence {Fence (A)} by loosening the 6mm wing bolt (A).
(2) The screw holder can be raised or lowered according to the height of
the workpiece by loosening the 6mm wing bolt (B). After the adjustment,
fi rmly tighten the 6mm wing bolt (B) and fi x the screw holder.
(3) Turn the upper knob and securely fi x the workpiece in position (Fig. 21).
Screw holder
6mm Wing
bolt (B)
Fence
Vise shaft
6mm Wing bolt (A)
Fig. 21
WARNING:
Always fi rmly clamp or vise to secure the workpiece to the fence;
otherwise the workpiece might be thrust from the table and cause
bodily harm.
English
Line
Knob
Vise plate
Work piece
11