Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Vise assembly
Move
Laser line
Groove
Fig. 19
Laser line
Marking
(pre-marked)
Fig. 20
NOTE:
Check and make sure on a periodic basis if the position of the laser line
is in order. As regards the checking method, draw a right-angle ink line
on the workpiece with the height of about 25/32" (20 mm) and the width of
5-29/32"(150 mm), and check that the laser line is in line with the ink line
[The deviation between the ink line and the laser line should be less than
the ink line width (0.5 mm)]. (Fig. 20)
PRACTICAL APPLICATIONS
WARNING:
* To avoid personal injury, never remove or place a workpiece on the
* Never place your limbs inside of the line next to warning sign while
Adjuster
(2) Then, turn the adjuster and shift the laser line. (If you
Turn
(3) After adjusting the position of the laser line, draw a
table while the tool is being operated.
the tool is being operated. This may cause hazardous conditions
(see Fig. 21).
turn the adjuster clockwise, the laser line will shift to
the right and if you turn it counterclockwise, the laser
line will shift to the left.) When you work with the ink
line aligned with the left side of the saw blade, align
the laser line with the left end of the groove. (Fig. 19)
When you align it with the right side of the saw blade,
align the laser line with the right side of the groove.
right-angle ink line on the workpiece and align the
ink line with the laser line. When aligning the ink line,
slide the workpiece little by little and secure it by
vise at a position where the laser line overlaps with
the ink line. Work on the grooving again and check
the position of the laser line. If you wish to change
the laser line's position, make adjustments again
following the steps from (1) to (3).
English
23
Tabla de contenido
