Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
6.
Always turn off tool and wait for saw blade to stop before moving workpiece or changing
settings.
7.
Always disconnect power before changing blade or servicing.
8.
Saw blade diameter is 12" (305 mm).
9.
No load speed is 4,000/min.
10. To reduce the risk of injury, return carriage to the full rear position after each crosscut
operation.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
Repairs should be conducted only by a Hitachi authorized service center.
USE PROPER EXTENSION CORD
Make sure your extension cord is in good condition. When using an extension cord, be sure to
use one heavy enough to carry the current your product will draw. An undersized cord will cause
a drop in line voltage resulting in loss of power and overheating. Table shows the correct size to
use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier
gage. The smaller the gage number, the heavier the cord.
Ampere Rating
More
Not More
Than
Than
0 – 6
6 – 10
10 – 12
12 – 16
WARNING:
Avoid electrical shock hazard. Never use this tool with a damaged or
frayed electrical cord or extension cord.
Inspect all electrical cords regularly. Never use in or near water or in
any environment where electric shock is possible.
8
MINIMUM GAGE FOR CORD SETS
Total Length of Cord in Feet (Meter)
0 – 25
(0 – 7.6)
(7.9 – 15.2)
18
18
16
14
26 – 50
51 – 100
(15.5 – 30.5)
AWG
16
16
16
14
16
14
12
Not Recommended
101 – 150
(30.8 – 45.7)
14
12
12
Tabla de contenido
