Paper Jams; Operating Precautions For Serial Interface - Citizen CT-S310II Manual De Usuario

The status display for various messages is shown below.
Status
Paper-end
Paper cover open or front
*1
cover open
Paper cover open or front
*2
cover open
Cutter locked
Memory error
Print head hot
Low-voltage error
High-voltage error
System error
Waiting for macro to execute
Power Save Mode
Notes:
*1: If the paper cover or front cover is open in standby.
*2: If the paper cover or front cover is open when printing or feeding paper.
*3: Buzzer sounds when MSW5-1 (buzzer setting) is set to ON. However, the conditions under which
the buzzer sounds vary depending on the settings of MSW6-1 and MSW10-6.

4.7 Paper Jams

Take care to avoid obstruction of the paper outlet and paper jamming around
theoutlet during printing.
If paper cannot get out of the printer, it can roll up on the platen inside the
printer andcause an error.
If the paper wraps around the platen, open the paper cover and carefully pull
thepaper out.

4.8 Operating Precautions for Serial Interface

White stripes may appear in the printout or the paper may not feed, depending
on the printing conditions, when using a serial interface. To prevent this, change
the memory switch settings shown as below.
1. Increase the transmission speed of the MSW7-1 (serial port).
2. Lower the MSW10-2 (print speed) level.
CAUTION
The transmission speed of the serial interface, ambient temperature, print data duty,
and other printing conditions may cause these problems even after doing the above
settings.
POWER LED
(green)
Lights
Lights
Lights
Lights
Lights
Lights
Lights
Lights
Lights
— 37 —
ERROR LED
(red)
Lights
Lights
—
—
*3
Buzzer
Yes
No
Yes
Yes
No
Yes
No
No
No
No
No