cecotec Conga Rockstar 300 X-Treme ErgoWet Manual De Instrucciones página 21

immediately with soap and water. If the liquid gets into
the eyes, flush them immediately with clean water for a
minimum of 10 minutes and seek medical attention. Wear
gloves to handle the battery and dispose of immediately in
accordance with local regulations.
• Avoid contact between the battery and small metallic
objects such as paper clips, coins, keys, nails or screws.
• Before a new battery is used or the battery is used for the
first time after long-term storage, fully charge the battery.
When the device is stored and not used for long periods
of time, ensure that the battery pack is fully charged, and
ensure that the battery is charged and discharged at least
once every three months.
3. BEFORE USE
1. Take the product out of the box.
2. Check for any visible damage, if any is observed, contact as soon as possible the Technical
Support Service of Cecotec for advice or reparation.
4. PRODUCT ASSEMBLY
VACUUMING TUBE AND SUCTION BASE ASSEMBLY
To install the suction base into the vacuuming tube, align both of
them making sure the tab on the suction base matches the guides
on the tube, and introduce one into the other until they are firmly
fixed. To disassemble them, press the suction base release button
and pull from the vacuuming tube while you hold the suction base.
Note: when assembling these 2 parts, make sure the handle and the
brush are facing the same direction.
Use the Flex tube to reach and clean the most difficult areas and
dirt. to bend the tube, press the Flex button.
BATTERY AND HANDHELD VACUUM CLEANER ASSEMBLY
1. Introduce the battery in the slot located in the handheld vacuum cleaner. Once
it is introduced, move it slightly to ensure it is properly assembled in place.
CONGA ROCKSTAR 300 X-TREME ERGOWET
ENGLISH
21