Hisense Hi-Therma Serie Manual De Instrucciones página 16

3 Remove the 4 L-shaped feet at 4 corners,and then remove
the indoor unit from wooden pallets, and place it carefully on
the floor, as near as possible to its final location.
●
Be careful with the Installation and Operation manual and with
the factory-supplied accessories located on the top of the unit.
● Two people are required when handling because of the weight
of the unit.
shaped feet
5
4.2 FACTORY-SUPPLIED INDOOR UNIT
COMPONENTS
Accessory Image
Gasket
Shut-off valve
with filter (G1")
Cable tie
Drain pipe
clamp
Drain pipe
Instruction
manual
Energy
efficiency label
Pressure relief
valve
●
The previous accessories are supplied inside the packing
assembly (on the top of the indoor unit).
● Additional refrigerant piping (field supplied) for connections to
outdoor unit needs to be available.
●
If some of these accessories are not packed with the unit or
any damage to the unit is detected, please contact your dealer.
BEFORE OPERATION
Qty. Remarks
12 gaskets for each
connections between the
12 indoor unit and shut-off
valves (inlet/outlet) .
(6 of G1" and 6 of G3/4")
Connect at the water inlet
of indoor unit, used to shut
1
off the water flow and filter
impurities in water.
3 Used for wiring binding.
Used for fastening drain
1
hose and drain pipe.
Used for drain hose of
1 pressure relief valve
connection
Basic instructions for the
1
installation of the device.
1 Energy efficiency label
1 Used for pressure relief for
DHW