Idiomas disponibles
Idiomas disponibles
INITIAL OPERATION
WARNING! Electric voltage:
wer cord is damaged or there is a suspicion of an invisible defect (e.g. after
a fall).
WARNING:
visible damage!
- Only put the device into operation when it is fully assembled!
- Place the device in an upright and stable position.
Connect the power adapter
The device responds with a beep and is ready for operation.
OPERATING
The functions, except for the operation mode, can be selected both on the control
panel
of the device and on the remote control
Note
Before using the remote control for the first time, activate it by pulling the plastic
tab out of the battery compartment.
No. Designation
17
POWER button
18
SPEED button
19
Oscillation button Each press increases the radius of the even venti-
20
TIMER button
21
MODE button
Do not operate the appliance if parts of the device show
to the foot
Meaning
Switching the device on and off.
Press the button repeatedly until the desired level is
shown in the status display. Each LED shows 2 levels:
1. = soft light, 2. = bright light, etc.
lation by 30° until it returns to 0°. To switch off the
oscillation, set it to 0°. The device continues to run in
the set operating mode.
Each press extends the number of hours until auto-
matic switch-off by double the number of hours until
it returns to 0. To switch off the timer, set it to 0.
Press the button repeatedly to change the operating
mode.
1 × = Natural mode: The fan changes the air speed
at intervals to simulate the feeling of natural wind
movement.
2 × = Sleep mode: The fan reduces the air speed to
the lowest level at intervals.
3 × = Normal mode: The fan run at the set speed
level.
Do not operate the appliance if the po-
and to a mains socket.
(Figure B, page 2).
GB
13
