Idiomas disponibles
Idiomas disponibles
GB
ASSEMBLING
Remove the fan from the packaging. Check the parts for possible transport
damage to avoid hazards.
Note
Parts of the device that are not included with the accessories are pre-assem-
bled on the individual parts.
INDIVIDUAL PARTS (Figure A, page 2)
Motor (with stand)
Foot (with status display)
Rear guard
Front guard
Latch
Blade nut
Attachment ring (for the rear
guard)
Blade
Proceed with the assembly according to the illustrations on page 46 and 47:
1. Loosen and remove the blade nut
nut
. Keep these handy.
2. Place the motor element on the foot
cable compartment.
3. Put on the cover nut
4. Remove the cable cover
cover
.
5. Fit the rear guard
three pins on the motor head and the three holes in the protective grille).
Screw on the attachment ring
clockwise. Tighten firmly!
6. Fit the blade
shaft. Put on the blade nut
7. Loosen the fixing screw
8. Push the front guard
locking points and engaging the two clips. Press firmly!
9. Hook in the latch
12
and tighten it.
. Plug in the connectors. Then replace the cable
accurately onto the motor head (Pay attention to the
accurately. Pay attention to the guide pins on the motor
and tighten it counterclockwise.
on the front guard
onto the rear guard
and secure it with the fixing screw
Cover nut
Cable cover
Fixing screw for latch
Power adapter (with plug)
Connector
Control panel (on the motor head)
Remote control
, the attachment ring
and insert the connector
for the rear guard
and open the latch
by placing the guard on the
and the cover
into the
.
.
