Hopper Dust Control Filter - Advance CS7000 Serie Instrucciones De Uso

A-32 / ENGLISH

HOPPER DUST CONTROL FILTER

The hopper dust control fi lter must be cleaned regularly to maintain the effi ciency of the vacuum system. Follow the recommended fi lter service
intervals for the longest fi lter life.
CAUTION!
Use only the approved Advance high capacity dust control fi lter in this machine. Use of standard pleated fi lters will result in
insuffi cient air fl ow, inadequate clean shaking, and potential machine damage.
Wear safety glasses when cleaning the fi lter.
Do not puncture the paper fi lter.
Clean the fi lter in a well-ventilated area.
To remove the hopper dust control fi lter...
1 See Figure 16. Unlatch the Hopper
Cover Latches (16) and lift the
Hopper Cover.
2 Loosen the two Thumb Nuts (HA),
then slide the Filter Shaker Motor
Assembly (HB) to the left and lift it
out of the hopper.
3 Hang the shaker assembly on the
hopper cover Hinge Hook (HC).
4 Inspect the top of the Hopper Dust
Control Filter (17) for damage. A
large amount of dust on top of the
fi lter is usually caused by a hole in
the fi lter or a damaged fi lter gasket.
5 Lift the Hopper Dust Control Filter
(17) out of the machine.
6 Clean the fi lter using one of the
methods below:
Method "A"
Vacuum loose dust from the fi lter.
Then gently tap the fi lter against
a fl at surface (with the dirty side
down) to remove loose dust and dirt.
NOTE: Take care not to damage the
gasket.
Method "B"
Vacuum loose dust from the
fi lter. Then blow compressed air
(maximum pressure 100 psi) into the
clean side of the fi lter (in the opposite
direction of the airfl ow).
7 Follow the instructions in reverse
order to install the fi lter. If the gasket
on the fi lter is torn or missing, it must
be replaced. NOTE: Be sure to
reinstall so that the air fl ow decal is
pointing up as shown.
A-32 - FORM NO. 56041979 - CS7000
FIGURE 16