Main Broom Switch; Side Broom Switch; Dust Control Switch; Filter Shaker Switch - Advance 7765 Instrucciones De Uso

A-10 / ENGLISH
OPERATIONS OF CONTROLS AND GAUGES

MAIN BROOM SWITCH

The Main Broom Switch (F) is located on the console to the right of the steering wheel in the SWEEPING section. This switch will activate the Main
Broom. This switch has two positions "ON" and "OFF". See Sweeping Broom Lift Control.
SIDE BROOM SWITCH (OPTION FOR MANUAL DUMP MACHINES)
The Side Broom Switch (G) is located on the console to the right of the steering wheel in the SWEEPING section. This switch will activate the Side
Broom. This switch has two positions "ON" and "OFF". See Side Broom Lift Control.
DUST CONTROL SWITCH (WET SWEEP BYPASS OPTION - OPTION FOR MANUAL DUMP
MACHINE)
The Dust Control Switch (H) is located on the console to the right of the steering wheel in the SWEEPING section. This switch will activate the dust
control system.
FILTER SHAKER SWITCH (VARIABLE DUMP MACHINES ONLY)
The Filter Shaker Switch (I) is located on the console to the right of the steering wheel in the SWEEPING section.
THE MAIN BROOM SWITCH MUST ALWAYS BE PLACED IN THE OFF POSITION BEFORE SHAKING THE FILTER. FAILURE TO DO SO
WILL RESULT IN DUST REMAINING ON THE SURFACE OF THE FILTER ENVELOPES INSTEAD OF DROPPING INTO THE HOPPER.
The button can be used when the ignition key is in the "ignition" position. The fi lter shaker control button is used during the sweeping cycle and the
hopper unloading cycle. Use the fi lter shaker control switch to remove dust from the fi lter. Use the following procedures to operate the fi lter shaker
control switch:
1. After the machine has made a long sweeping run, turn the broom switch to the "OFF" position.
2. Push the fi lter shaker control switch for 5 to 15 seconds to allow the fi lter to unload.
3. Turn the broom switch to the "ON" position. Repeat this procedure after each long sweeping run.
FIGURE 4
The main broom, side broom, dust control and fi lter shaker turn off automatically when the hopper is dumping and/or the dump door is
A-10 - FORM NO. - 56041801 - 7765
NOTE - (Variable Dump Machines Only)
F
H
NOTE - (Variable Dump Machines Only)
in a closed position. SEE HOPPER LIFT and HOPPER DUMP DOOR.
G
I