(B)-Installing The Batteries; Battery Installation; Pad Installation; Dust Bag Installation - Advance Advolution 24B Instrucciones Para El Uso

PREPARING THE MACHINE
FOR USE

(B)-INSTALLING THE BATTERIES

1 Carefully lift the batteries into the battery tray. Arrange as shown in
Figure B.
B
2 Make sure the key switch is in the OFF position.
3 Install the battery cables as shown in figure B, with the terminals marked "P"
on the positive battery posts and the terminals marked "N" on the negative
battery posts. Position the cables so that the caps can be easily removed
when it is necessary to add water to the batteries.
4 Tighten the nut on each battery terminal just enough to keep the terminal from
being turned on the battery post. Then tighten the nut one more full turn.
5 Coat all the terminals and posts with grease, petroleum jelly or spray-on
battery coating (available at most auto parts stores).
6 Put on the black rubber "boots" over each of the terminals and use the plastic
tie straps to hold them in place.
7 Join the connector from the battery pack to the connector on the control panel.
8 Reassemble machine.
NOTE: Charge the batteries before using the machine.
(C)-PAD INSTALLATION
Your local Nilfisk-Advance distributor can provide the proper pads and floor finishes
for use with this machine.
CAUTION!
Using the wrong kind of pad on this machine can damage
the floor. The pad must be centered properly on the pad
holder to prevent machine vibration.
For pad installation, follow the steps below (see steps 1 - 6 in Figure C):
1 Turn the key switch off.
2 Put the machine in the position shown, to access the pad retainer.
3 Go to the front of the machine. While holding the pad retainer with one hand,
rotate the pad and pad driver counter clockwise to loosen the pad retainer.
4 Remove the old pad and install a new one, being careful to center it on the outside
diameter of the pad driver. NOTE: Vibration could occur if you center the
hole in the pad to the opening for the pad retainer. Always use a high
quality pad rated to operate at 2000 rpm.
5 Retighten the pad retainer as tight as possible.
6 Raise the back of the machine to lower the pad housing by lifting as shown.
(D)-DUST BAG INSTALLATION
Your local Nilfisk-Advance distributor can provide the proper pads and floor finishes
for use with this machine.

IMPORTANT!

Install dust collector bag (part number 56201569) on top of
control housing (see Figure D). The dust collection system will
not operate properly if the collector bag is full or torn.
FORM NO. 70523A - Advolution 24B, 24BT - 7
EN
ENGLISH