Idiomas disponibles
Idiomas disponibles
INSTALLATION
Install the mixer on a hard and horizontal soil
in order to ensure a good stability to the
machine.
Clear the surroundings of the machine from all
thing likely to occasion a risk of accident or to
impede the operator.
Before starting your mixer make sure
that :
Electric driven mixer
• The tension of the network is 230 volts on
two wires.
• Minimum capacity of the meter should be 5
Amps.
• The motor hood set benefits from double
insulation class II.
• Foresee a two wires supply cable having a
section of 2,5 mm2 for a maximum length of
50 m (equipment class II no need for a ground
wire). If length is more than 50 m, foresee a
cable with a bigger section.
SAFETY INSTRUCTIONS
General
Before starting your mixer, check that :
• all protection devices are in position and
good condition.
• Nobody is into contact or close to the mixer,
and no tool is leaning against it.
• Never let a cable rolled on its support, this
will cause impodant drops of tension and lead
to overheating.
• The line must be fitted with fuses or circuit
breaker to ensure the protection.
• Do not plug in and use the electric motor
without making sure that the motor hood is
closed.
GB
MAINTENANCE
• After each use, clean the inside and the
outside of your mixer. If you wash it with a
high pressure cleaner, make sure that the
water projections do not reach the motor.
• For a good and efficient leaning of the drum,
use a shovel of gravels and water.
• Do not forget from time to time to grease the
bearing of the bracket, a hole is foreseen for
this.
• The bearings of the drum and of the driving
axle are greased for life.
• Sound pressure 74 dB(A) to 1 m.
MAINTENANCE
The pinion driving the drum is a wearing part
of your mixer. In order to avoid any
immobilization,
to foresee a replacement beforehand.
13
it
is
recommended
