Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for impact drilling in wood and metal.
ASSEMBLY AND OPERATION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and disconnect tool from power source when changing
accessories. Always ensure the bit is secure before starting the tool. Damage to the Chuck or a loose bit
may cause possible personal injury.
--Removing the bits
--Inserting the bits
OPERATION
FORWARD/REVERSE ROTATION CONTROL
WARNING: Never change the direction of rotation when the chuck is
rotating, wait until it has stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING
OPERATING THE ON/OFF SWITCH
WARNING: Do not operate for long periods at low speed because excess
heat will be produced internally.
LED LIGHT INDICATOR (See Fig. G)
Before operation, the LED light will be activated when the On/Off switch is slightly depressed.
The tool and battery are equipped with a protection system. When the LED Light is quickly flashing 60 seconds
and turns off, the system will automatically cut off power to the tool to extend battery life. The tool will
automatically stop during operation if the tool and/or battery are placed under one of the following conditions:
• Overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation,
release the Trigger Switch on the tool and stop the application that caused the tool to become overloaded. Then
pull the Trigger Switch again to restart.
• Overheated: Under the condition above, if the tool does not start, the tool and battery are overheated. In this
situation, let the tool and battery cool before pulling the Trigger Switch again.
• Low battery voltage: The remaining Battery capacity is too low and the tool will not operate. In this situation,
remove and recharge the Battery.
WARNING: To turn on the light, press the On/Off switch and make sure the Forward/Reverse Rotation
Control is on right/left position.
Lithium-Ion Cordless Drill Driver
ACTION
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B1
See Fig. B2
See Fig. C1, C2, C3
See Fig. D
See Fig. E
See Fig. F
EN
11
