Idiomas disponibles
Idiomas disponibles
CLEANING THE MOTORIZED BRUSH AND BLOCKAGES
The brush roll may accumulate debris such as strings, hair and fibers. This type of debris
can wrap around the brush and diminish its ability to clean effectively. The Easy-Cut blade
in the Powerhead housing will automatically cut most debris accumulation away from the
brush roll.
Recommended: After every use, clean
the brush roll with the Easy-Cut system by
stepping on the button as illustrated while
the brush roll is spinning.
To Remove Brush Roll For Manual Cleaning:
1. Ensure the vacuum is OFF.
2. Turn unit over to
access the brush roll.
3. Unlock the
brush roll tab
with flat head
screwdriver
or similar tool
as illustrated.
4. Lift the
brush roll out
of the housing.
Clean off debris
and anything
wrapped around
the brush.
5. Place the
brush roll into
the housing by
aligning the end
to the brush drive
first, then inserting
the other end correctly
into place. When installed
correctly, the brush roll should
spin freely.
6. Lock the brush in
place by closing the
tab as illustrated.
To Remove Hose
Blockages:
1. To clean out the
hose, press the
hose release tabs,
as illustrated, and
pull the motorized
brush powerhead
away from the main
vacuum body.
2. Carefully remove any
debris or blockage from
the inside of the hose.
Reattach the motorized
brush powerhead onto
the vacuum body.
NOTE: Do not use scissors or other sharp
objects to remove a blockage from the
hose as these may damage the hose.
WARNING
This product contains the EASY-CUT blade.
Do not touch the blade when performing
motorized brush maintenance.
EASY-CUT BLADE
- 11 -
1
1
