Idiomas disponibles
Idiomas disponibles
Winch Installation to fixed location
Failure to observe these instructions could lead to minor or moderate injury.
Always choose a mounting location that is sufficiently strong to withstand the loads you
intend to winch
The 2000 can be mounted to a fixed location
by utilizing the mounting hole pattern for
the winch unit. First, choose a mounting
location that is sufficiently strong enough to
withstand the loads you intend to winch.
Next, drill two hole to the dimensions
specified in the drawing below.
To secure the winch, always use:
A flat, secure mounting location at
▫
least 3/16 in. (4.8 mm) thick steel.
5/16 in. flat washer x 2.
▫
5/16 in. lockwasher x 2.
▫
5/16-18 x 1in. long, hex head
▫
capscrew, Grade 5 or better x 2.
Torque mounting bolts to 12 ft-lbs
▫
(16.3 Nm).
Bolt length may need to be longer that
specified above depending upon the thickness
of the material the winch is mounted to.
Caution
Winch Failure Hazard
3.1"
[78.7 mm]
PAGE 8
5/16" [7.94 mm] DIA (2 plcs)
91728A0
