Replacement Parts - Carrera 521 Manual De Instrucciones

Cleaning after dry shaving
1. Press the lateral unlocking buttons 4 and remove the shaving
head 2 .
2. Knock the shaving head on a flat surface and/or blow it out.
3. Clean the cutting blades with the cleaning brush.
CAUTION!
Do not use force and do not press onto the shaving foil!
Wet cleaning
1. Before cleaning, unplug the 5V plug 12 from the shaver (see fig. A
and B).
2. Use the on/off switch 6 to switch off the shaver.
3. Press both unlocking buttons 4 to release the shaving head 2
(see fig. E).
4. Pull off the shaving head 2 in an upward direction (see fig. A).
5. Carefully clean the inside and outside of the shaving head under
warm, running water (see fig. G).
6. Hold the shaver above the sink.
7. Carefully rinse the upper part of the shaver and the cutting
blades under warm, running water (see fig. H).
8. Use the on/off switch 6 to switch on the shaver without the shav-
ing head attached. Let it run for approx. 5–10 seconds to shake the
water drops off the cutting blades 3 .
9. Allow the parts to dry well.
10. Firmly attach the shaving head to the shaver until it locks into place
with an audible click (see fig. F).
11. Replace the protective cap 1 on the shaver.
The shaver is again ready for operation.
NOTE: Apply 1–2 drops of acid-free oil (e.g. sewing machine oil) onto
the cutting blades and the long hair trimmer, especially after wet
cleaning and the replacement of spare parts. Let the appliance run for
a couple of seconds without using it. Use a soft cloth to wipe off the
excess oil, if necessary.
34 GB

08. REPLACEMENT PARTS

Cutting elements are subject to natural wear and excluded from the
warranty. In order to achieve optimum shaving results, it is indispensa-
ble to replace these parts in time.
You can order the following replacement parts:
Shaving foil / cutting blades
● ●
4-track shaving system (4-track shaving system with integrated long
● ●
hair trimmer and 3 spring-loaded cutting blades).
Recommended replacement intervals
To guarantee optimum cutting performance, we recommend replacing
the shaving foils and cutting blades at the latest every 12 months.
Since both cutting parts adapt to each other over time, we recommend
replacing the shaving foil and cutting blade at the same time.
The replacement parts can be ordered online or via the Service Centre.
Replacing the parts
WARNING! Risk of cutting injuries!
Carefully pull the three cutting blades off the white plastic
holder.
1. Remove the protective cap.
2. Press the unlocking buttons 4 on both sides and remove the shav-
ing head.
3. Tilt the old cutting blades out of their holder (see fig. J).
4. Grasp the new cutting blades on both ends between your thumb
and index finger and insert them into the white holder. Briefly press
the cutting blades down until they lock into place with an audible
click.
5. Remove the old shaving foil frame from the shaving head frame.
With a fingernail, grasp behind one of the two flaps (see fig. K) on
the shaving foil frame and tilt it out.
6. Carefully press the new shaving foil frame into the shaving head
frame until it locks in place with an audible click.
GB 35