Idiomas disponibles
Idiomas disponibles
CLEANING THE DEBRIS FILTER
We recommend cleaning the debris filter when water does not drain well or the "ND" error message is
displayed.
1. Open the filter cover by pressing and pulling the handle of the
filter cover with your finger.
2. Unscrew the drain cap by turning it
counterclockwise.
3. Hold the cap on the end of the drain tube and
slowly pull it out about 6 inches (15 cm) and
drain off all the water.
4. Remove the debris filter cap.
5. Wash any dirt or other material from the debris filter. Make sure
the drain pump propeller behind the debris filter is not blocked.
6. Replace the debris filter cap.
7. Replace the filter cover.
WF338AA-02562A-01_EN.indd 19
Step 1
Step 2
Maintaining your washer _19
2008-03-10 ¿ÀÈÄ 3:35:50
