Idiomas disponibles
Idiomas disponibles
SE 2320
• When the hairdryer is used in a bathroom, unplug it after
use since the proximity of water presents a hazard even
when the hairdryer is switched off.
• For additional protection, the installation of a residual
current device (RCD) having a rated residual operating
current not exceeding 30mA is advisable in the electrical
circuit supplying the bathroom. Ask your installer for
advice.
DRYING
1. Put the plug in the wall socket.
2. Switch the appliance on by selecting the desired setting.
3. The airflow and temperature can be adjusted:
Speed setting
2: high speed
1: low speed
0: Off.
- Use setting "2" and setting "Ⅲ" for fast drying or pre-drying.
- Use setting "1" and setting "I" or "II" for gentle drying and styling.
- After drying hair, can use the cool button to set style with a continuous flow of cool air.
4. Dry your hair by making brushing movements while holding the dryer at a small distance from your hair.
STYLING ATTACHMENTS
Concentrator
The concentrator enables you to direct the airflow at your hair that you are styling.
Connect the concentrator by simply snapping it onto the appliance. Disconnect it by pulling it off.
Diffuser
You can use for curl your hair.
CLEANING
1. Turn this appliance off before cleaning.
2. Remove the grill in order to eliminate the dust and hair.
3. The appliance can be cleaned with a dry cloth.
4. L'appareil peut être nettoyé avec un tissu sec.
5. The attachments can be cleaned with a moist cloth or rinsed under a running tap.
Remove the attachments from the appliance before cleaning them. Make sure the attachments are dry
before using or storing them.
Never rinse the appliance with water.
STORAGE
When not in use "unplug it."
Allow the appliance to cool and store it in a dry location. This hair dryer features a loop allowing it to be
conveniently hung on a hook for easy access. Never wrap the cord around the appliance since this will cause
the cord to wear prematurely and break. If the supply cord of this appliance becomes damaged the appliance
must be replaced by its manufacturer, its Service Agent or a similarly qualified person in order to avoid a
hazard
Heat setting
Ⅲ: high heat
II: medium heat
I: low heat
8
