Hilti CD 4-A22 Manual De Instrucciones Original página 24

Vibration information
Vibration value ah,D
Uncertainty for the stated vibration values K
5 Preparations at the workplace
5.1 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.1.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.1.3 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.2 Installing the scaffold hook (accessory)
▶ Install the scaffold hook.
5.3 Preassembly of cartridge holder for cartridges
1. Hold the release button pressed.
2. Guide the appropriate (short) piston rod into the power tool so that the toothing is at the bottom.
3. Position the grip at the rear on the piston rod and fix it in place with the screw.
4. Screw the cartridge holder onto the connecting sleeve.
5.4 Preassembly of aluminum tube for foil packs and cartridges
1. Hold the release button pressed.
2. Guide the appropriate (long) piston rod into the power tool so that the toothing is at the bottom.
3. Position the grip at the rear on the piston rod and fix it in place with the screw.
Make sure that the piston attachment for foil packs is mounted on the piston rod.
18 English
Printed: 29.07.2019 | Doc-Nr: PUB / 5466569 / 000 / 02
6
2
3
2221132
CD 4­A22
0.07 m/s²
(0.23 ft/s²)
0.01 m/s²
(0.03 ft/s²)
*2221132*