Home Decorators Collection ALTURA 26655 Guía De Uso Y Mantenimiento página 13

Operating Your Fan and Remote Control
Setting the code on the remote control
NOTE: This remote is equipped with 16 code combinations. To prevent
possible interference from or to other remote units, such as garage
door openers, car alarms, or security systems, simply change the
combination code. The code switch marked ON/DIM is for dimming
control of the lights: Set the code switch to ON to allow for no dimming
of the lights such as for fluorescent bulbs. Set the code switch to DIM
to allow for dimming of the lights.
NOTE: If using a light kit, the light switch located on the light kit
should be at "ON" position before operating the remote control.
□
Remove the battery cover by pressing firmly on the arrow
and sliding the cover off.
□
Slide the code switches to your choice of either up or down.
The factory setting is up.
□
Install a 12-V battery (included).
□
Replace the battery cover on the remote control.
Learning process
NOTE: After the AC power is on, do not press any other button on
the remote control before pressing the "FAN OFF" button (V V).
Doing so will cause the procedure to fail.
NOTE: The remote control can learn multiple receivers. Make sure
no other receivers are operating during the learning process.
Separate the fan power switches by approximately 2 meters.
Should you desire to use another remote control unit with your
new fan, install one using the steps below:
□
Turn the main power source off to begin the learning process.
□
Remove the remote control battery cover to set the dip switches
to the desired combination. Use a small size tool, such as a ball-
point pen or small screw driver, to change the frequency settings
on the control system. The receiver will automatically learn the
frequency code.
□
Return the power to the unit.
□
Within 30 seconds of turning the fan's AC power ON, press and
hold the "FAN OFF" button (V V) for 5 seconds. Once the receiver
has detected the set frequency, the down light of your fan, if
applicable, will blink twice. There is no indication if your fan is
not equipped with a light.
ON DIP
ON DIM
1 2 3 4
12V 23A
13
Please contact 1-800-986-3460 for further assistance.
ON DIP
ON DIM
1 2 3 4
V V
HOMEDEPOT.COM/HOMEDECORATORS