Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
INSTALLATION
• Install the appliance away from heat sources. Installation in a hot environment, direct
exposure to the sun or installation near heat sources (heaters, radiators, cookers) will
increase power consumption and should therefore be avoided.
• If this is not possible, the following minimum distances must be respected:
• 30 cm from coal or paraffin stoves;
• 3 cm from electric and/or gas stoves.
• Fit the spacers (if supplied) on the rear of the condenser positioned at the back of the
appliance (see figure).
• To optimize appliance efficiency, leave a 5 cm gap above the appliance and make
sure that adjacent kitchen units are sufficiently distanced to allow air circulation.
• Install the appliance in a dry, well-ventilated place, and ensure it is level, using the front
adjustment feet if necessary.
• Clean the interior.
• Fit the accessories.
Electrical connection
• Electrical connections must be made in accordance with local regulations.
• Voltage and power consumption are indicated on the rating plate inside the
appliance.
• Regulations require that the appliance is earthed.
The Manufacturer declines all liabilities for injury to persons or animals or damage to
property resulting from failure to observe these regulations.
• If the plug and socket are not of the same type, have the socket replaced by a
qualified electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by unplugging it or by means of a two-
pole switch fitted up line of the socket
22
