Idiomas disponibles
Idiomas disponibles
AC24NE
New Remote
A
B
(Press A/B button
you selected)
2) Make sure that the LED display shows the "OSC" or "PED" three times quickly. The code is corresponding to the selected
command. ( gure 2)
3) Repeat step 1 & 2 within 10s, if there are other remotes to be memorized for the same type of command. No action within
10s, the memorization stage will terminate automatically.
Deleting memory of single command
Single deletion stage is needed for each memorized button.
1) Press and hold down RF-LEARN button (Figure 3) on the control board for 5 seconds.
2) Wait until the LED display shows "DKY", then, within three seconds:
3) Press the button of the remote to be deleted. If the remote has been deleted, the LED display will ash quickly ve times.
4) Repeat above steps if more button to be deleted.
DKY
5 sec
(Figure 3)
Deleting all memory of all remotes:
With this operation all the memorized transmitters will be deleted.
1) Press and hold down RF-LEARN button (Figure 4) on the control board for 10 seconds.
2) Wait until the LED display shows "DAL". (When you see DKY, keep pressing the RF-Learn till it shows DAL). All memory
is deleted.
(Figure 3)
(Figure 2)
OSC
(RF-LEARN)
PED
A
B
Opening your life
DKY
Flashes 5 times
1 14
