Tintometer Lovibond MD100 Instrucciones página 99

All manuals and user guides at all-guides.com
Operating messages – Error codes
GB
Operating messages
Hı
Measuring range exceeded or excessive turbidity.
Lo Result below the lowest limit of the measuring range.
Replace batteries, no further tests possible.
Battery capacity is too low for the display backlight;
btLo
measurement is still possible.
Store Date
A user calibrated method is indicated by an arrow while the test result
Cal
RESULT
is displayed (see "Factory calibration reset").
Time Cal
Error codes
E27 / E28 / E29
Light absorption too great. Reasons: e.g. dirty optics.
E 10 / E 11
Calibration factor "out of range"
E 20 / E 21
Too much light reaching the detector.
E23 / E24 / E25
Too much light reaching the detector.
E 22
Battery capacity was too low during measurement. Change battery.
E 72
CL 6:
E 73 CL 6:
E 74 CL HR: Factory calibration incorrect / erased
CL HR: User calibration incorrect / erased
E 75
AL:
E 80
E 81 AL:
E 82 FE:
E 83
FE:
E 84
FE M:
E 85 FE M:
E 86 Cu:
E 87 Cu:
E 88 Zn:
E 89
Zn:
E 90 SO4:
E 91
SO4:
E 92 Mo 1: Factory calibration incorrect / erased
E 93
Mo 1: User calibration incorrect / erased
E 94
Mo 2: Factory calibration incorrect / erased
E 95
Mo 2: User calibration incorrect / erased
E 96
tri:
E 97 tri:
POLY:
E 98
POLY:
E 99
MD100_7 12/2016
Factory calibration incorrect / erased
User calibration incorrect / erased
Factory calibration incorrect / erased
User calibration incorrect / erased
Factory calibration incorrect / erased
User calibration incorrect / erased
Factory calibration incorrect / erased
User calibration incorrect / erased
Factory calibration incorrect / erased
User calibration incorrect / erased
Factory calibration incorrect / erased
User calibration incorrect / erased
Factory calibration incorrect / erased
User calibration incorrect / erased
Factory calibration incorrect / erased
User calibration incorrect / erased
Factory calibration incorrect / erased
User calibration incorrect / erased
99