Warranty & Maintenance; Troubleshooting; Technical Lnformation - Dreiha CoolingBox 45LR Manual De Instrucciones

Warranty & Maintenance
lf the device gets malfunctional, limited warranty will be provided for 1 year from the date of purchase,
except following situations:
• Contrived damage.
• Damage caused by force majeure such as earthquake, conflagration, etc.
• Damage from inappropriate use or violating this instruction.
• Damage or malfunction caused by disassembling.

Troubleshooting

Issues
Refrigerator does not work.
Refrigerator compartments are too warm.
Food is frozen.
There is a "water flow" noise from inside the fridge.
There are waterdrops around the refrigerator
casing or door gap.
The compressor is slightly noisy when starting.
Code F1 displayed.
Code F2 displayed.
Code F3 displayed.
Code F4 displayed.
Code F5 displayed.
Code F6 displayed.
Code F7 or F8 displayed

Technical lnformation

*Due to product improvement, the technical information might be different from actual information,
please refer to the rating la bel on the product.
Suggestions
• Check if the switch is on.
• Check if the plug and socket are connected well.
• Check if the fuse has been burnt.
• Check if the power supply is malfunctioned.
• Switching on/off the fridge frequently may cause start delay
of the compressor.
• The door is opened frequently.
• A large amount of warm or hot food was stored recently. Wait for
the refrigerator to reach its selected temperature.
• The refrigerator has been disconnected for a period of time.
• The temperature was set too low, please increase the temperature.
• lt' s a normal phenomenon, caused by the flow of refrigerant.
• lt' s a normal phenomenon, the moisture will condense to water
when it touches a cold surface of the refrigerator.
• lt' s a normal phenomenon, the noise will be reduced after the com-
pressor works stably.
• Possible cause: low voltage to fridge.
• Adjust the battery protection from H to M or from M to L.
• Possible cause: condenser fan is overloaded.
• Disconnect power to fridge for 30 minutes & re-start.
• Possible cause: the compressor starts too frequently.
• Disconnect power to fridge for 30 minutes & re-start.
• Possible cause: compressor not kicking in.
• Disconnect power to fridge for 30 minutes & re-start.
• Possible cause: overheating of the compressor & electronics.
• Disconnect power to fridge for 30 minutes & re-start.
• Possible cause: no parameter can be detected by the controller.
• Disconnect power to fridge for 30 minutes & re-start.
• Possible cause: temperature sensor is faulty.
• Contact manufacturer for service.
Disposal:
Place the packaging material in the
appropriate recycling waste
wherever possible.
lf you wish to finally dispose of the
product, ask your local recycling center
or specialist dealer for details about
how to do this in accordance with the -
applicable disposal regulations.
bins