Battery Operation - Dreiha CoolingBox 45LR Manual De Instrucciones

• Battery Protection Mode: under the running state, long press
protection mode H(High), M(Middle)
Due to the different output voltages between vehicles, H should be set when the product is connected to car power, and M or L should
be set when it is connected to a portable battery or other back-up battery.
The battery gear should be set from H to M or from M to L if there is a voltage protection code Fl shown on the panel. The battery gear
should be set to H if the product keeps working after turning off the car engine, or the product may drain the battery.
• Reference voltage:
MODE / INPUT
L
M
H
*the voltage is theoretical value, there may be a deviation in different sceneries.
• USB output: +SV DC/lA, suitable for small devices like mobile phones, tablets, etc.
• Temperature Unit Setting: switch off the fridge, long press
Under E5 mode, press or to select Celsius or Fahrenheit.
• Reset: switch off the fridge, long press
screen displays as below:
*Note: Except E5, other E settings are used for factory maintenance, reset it if you operate the setting mistakenly.
• Recommended temperaturefor common food:

Battery Operation

The refrigerator can be connected to 12V/24V DC power, 100~240V AC power, or use backup lithium battery if DC/AC power are not
available. The battery will also be charged simultaneously when the fridge is connected to DC/AC power.
• Battery charging: lf you want to charge the battery separately, switch off the refrigerator and connect the battery to 12V/24V DC
power, 100~240V AC power or solar
be used).
When the battery is charging, the power indicator turns green, and the four blue battery indicators will show the charging status in a
marquee manner; when the battery is fully charged, the power indicator will turn off, the battery indicators are always on.
and L(Low) (*Factory setting is H.)
DC 12V
CUT OUT CUT IN
9.0V 10.9V
10.1V 11.4V
11.1V 12.4V
(*Factory setting is ºC.)
for three seconds until E1 displays, under E1 mode, long press
(12~50V) (it is suggested that connect to AC power first, after charging 30%, other charging methods can
for three seconds until screen flashes, then press
CUT OUT
21.3V
22.3V
24.3V
for three seconds until E1 displays, then switch to E5 by pressing
Battery bank:
Model No.: FSAK-002
Battery Capacity: 15600mAH
Rated Voltage: 11.lV
Charging Limited Voltage(DC): 12.6V
Charging Limited Current(DC): 3A
Warning: do not disassemble the battery.
again to select
DC 24V
CUT IN
22.7V
23.7V
25.7V
at the same time until the
again.