Anti-Tip Tubes- Rear (Fig.4.7); Tilt-In-Space Mechanism - Quickie SR 45 Manual De Instrucciones

ANTI-TIP TUbES- REAR (fIG.4.7)

WARnInG!
Anti-tip tubes are recommended for all wheelchairs.
note: Use a torque setting of 14Nm, (120 in.-lbs), when
setting-up anti-tip tubes.
Inserting Anti-Tip Tubes Into Receivers
• Press the rear anti-tip release pin (A) on the anti-tip
tube so that both release pins are
• drawn inside of tube.
• Insert the anti-tip tube into the receiver (B).
• Turn the anti-tip tube down until front release pin
protrudes through the rear receiver
• mounting hole.
• Insert second anti-tip tube the same way.
Turning Anti-Tip Tubes Up
NOTE: Turn anti-tip tubes up when being pushed by
attendant, overcoming obstacles or climbing curbs.
• Press the rear anti-tip tube release pin (A).
• Hold pin in and turn anti-tip tube up (C).
• Release pin.
• Repeat with second anti-tip tube.
• Remember to return anti-tip tubes to down position
after completing maneuver.
Adjusting Anti-Tip Tube Wheel
The anti-tip tube wheels may have to be raised or
lowered to achieve proper ground clearance of 38-51mm
(1-1/2" to 2").
• Press the anti-tip wheel release pin (D) so that the
release pin is drawn inside.
• Raise or lower to one of the pre-drilled holes.
• Release pin (D).
• Adjust the second anti-tip tube wheel the same way.
Both wheels should be at exactly
• the same height.
B
A
22
Fig.4.7
Fig.4.8

tILt-In-SPAce MechAnISM

The tilt-in-space mechanism is installed by Sunrise
Medical.
The tilt mechanism positively locks the chair in place
from 0º to 45º.
Trigger Tilt Operation
Depressing both triggers (C) at the same time
disengages the locking mechanism and
allows the seat and back to rotate in space.
Releasing the triggers positively locks the
rockers in place.
The approximate degree of tilt the seat is at can be
seen on the tilt indicator (D).
To lock out the tilting function, insert the locking pin (E)
into the trigger holder.
foot Release
Depressing foot pedal (F) disengages the locking
mechanism and allows the seat and
back to rotate in space. Releasing the foot pedal
positively locks the rockers in place.
The approximate degree of tilt the seat is at can be
seen on the tilt indicator (D).
Tilt-stops Adjustment
Adjustments can be made to limit the amount of tilt
(rotation) that the chair provides by
using the tilt-stops (G).
• Loosen and remove the retaining screw (H).
• Locate the tilt-stops to the desired limit either
anterior or posterior.
• Each half of tilt stop assembly should plug into
directly opposing holes on the rocker (I), then
secure in place by tightening the screw (H).
Fig.4.9
Fig.4.10
Fig.4.11
SR45 Rev.1.0