Frame Depth; Frame Width; Seat Pan (Fig.4.22); Cushion Installation - Quickie SR 45 Manual De Instrucciones

fRAMe DePth

back adjustment (fig.4.18)
• Loosen and remove the bolts (A & B) located in front
of back mounting plate on both sides of the chair.
• Slide the backrest along the seat rail to the desired
position.
• Replace and tighten the bolts (A & B ) at desired
Bposition on both sides of chair.
cAutIon!
• The adjustment on each side of the chair should be
exactly equal.
• Use a torque setting of 14Nm (120 in.-lbs). When
setting-up back depth adjustment.
hanger Receiver Adjustment (fig.4.19)
• Loosen and remove the socket head screw (C) from
the seat rail.
• Slide the hanger receiver (D) in the seat rail to the
desired position.
• Replace and tighten the socket head screws.
• Repeat on the other side.
cAutIon!
These adjustments may also require re-positioning the
carriage over the base frame.
The adjustment on each side should be exactly equal.
Use a torque setting of 14Nm (120 in.-lbs). When setting-
up hanger receiver.

fRAMe WIDth

The frame is built to accommodate growth by using the
growth kit components.
Width Adjustment (fig.4.20-4.21)
• Remove the bolts (E) from both ends of the strut
tubes (F) for all strut tubes.
• Replace with the appropriate length strut tubes
• Tighten the bolts (E) at each end.
• Repeat for each strut tube.
B
Fig.4.19
c
D
24
Fig.4.18
A
cAutIon!
• Use a torque setting of 23Nm (200 in.-lbs). when
setting up rocker frame width.
Use a torque setting of 14Nm (120 in.-lbs). when
setting up base frame.

SeAt PAn (fIG.4.22)

The seat pan is designed to accommodate depth
adjustment. There are two different lengths of seat pans
to accommodate different seat depth ranges.
Loosen all four seat pan screws (G) and slide seat pan
forward or rearward so as to keep the front of the seat
pan approximately 12mm (1/2") behind the vertical tube
of the hanger receiver.
Re-tighten all four screws, ensuring the clamps are
completely engaged onto the seat tubes.
cAutIon!
If this causes front seat pan clamps to hang off the end of
the seat tube, or if the seat pan clamp would interfere
with the rocker, remove the screws completely from the
front seat pan clamps and re-align with appropriate holes
in the seat pan.

cuShIon InStALLAtIon

• Place cushion on seat pan with hook material side
down. The beveled edge of the cushion should be in
front.
• Press firmly into place.
e
Fig.4.20
G
f
e
Fig.4.21
e
f
Fig.4.22
SR45 Rev.1.0