Idiomas disponibles
Idiomas disponibles
• Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use tool while
tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating power tools may result in
serious personal injury.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask
if operation is dusty. ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA/Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
Tool Specifi cations
MODEL
DWFP71917
DESCRIPTION
16 Gauge Finish Nailer
ENGINE TYPE
Oil-Free
OPERATION PRESSURE
70 – 120 psig (4.9 – 8.43 kg/cm
RANGE
MAXIMUM OPERATION
120 psi (8.43 kg/cm
PRESSURE
AIR CONSUMPTION AT A
2.0 cfm (56.6 lt/min @
RATE OF 60 FASTENERS
80 psi (5.6 kg/cm
PER MINUTE *
FASTENER GAUGE
16 Gauge
FASTENER RANGE
1–1/4" to 2–1/2" (32 mm – 64 mm)
MAGAZINE CAPACITY
up to 100 Nails
LENGTH
12-1/2" (316.6 mm)
WIDTH
3-1/3" (84.1 mm)
HEIGHT
11-5/16" (288.5 mm)
WEIGHT
3.9 lbs (1.7 kg)
* The DWFP71917 requires 2.0 cubic feet per minute or cfm (56.6 liters
per minute or lt/min) of free air at 80 psi (5.6 kg/cm
rate of 60 fasteners per minute. To determine the appropriately sized
air compressor, take the actual rate at which the tool will be run and
compare the required cfm (lt/min) to the compressors free air delivery
(cfm/ lt/min) at 80 psi (5.6 kg/cm
5
2
)
2
)
2
)
2
) to operate at a
2
).
