Idiomas disponibles
Idiomas disponibles
Rotate the trigger mode selector (B)
counterclockwise to the contact action
position
, as shown in Figure 3.
To operate the tool using the
PLACE ACTUATION method:
WARNING: A fastener will fire each
time the trigger is depressed as long
as the contact trip remains depressed.
1. Depress the contact trip against
the work surface.
2. Depress the trigger.
To operate the tool using the BUMP ACTUATION method:
1. Depress the trigger.
2. Push the contact trip against the work surface. As long as the
trigger is depressed, the tool will fire a fastener every time the
contact trip is depressed. This allows the user to drive multiple
fasteners in sequence.
WARNING: Do not keep trigger depressed when tool is not in use.
Keep the contact trip lock-off engaged in the locked position when
the tool is not in use.
Tool Operation Check (Fig.1)
WARNING: If the tool is dropped or you suspect tool damage
perform tool operation check.
WARNING: Remove all fasteners from tool before performing tool
operation check.
SEQUENTIAL TRIP ACTION
A. Press the contact trip against the work surface, without touching
the trigger.
THE TOOL MUST NOT CYCLE.
B. Hold the tool off the work surface and pull the trigger.
FIG. 3
C. Pull the trigger and press the contact trip against the work
D. With finger off the trigger, press the contact trip against the work
CONTACT TRIP ACTION
A. With finger off the trigger, press the contact trip against the work
B. Hold the tool off the work surface, and pull the trigger.
C. With the tool off the work surface, pull the trigger. Press the
D. Without touching the trigger, press the contact trip against the
Loading the Tool (Fig. 4)
nails.
activated.
1. Load nails through the slot in the rear of the magazine and past
8
THE TOOL MUST NOT CYCLE.
surface.
THE TOOL MUST NOT CYCLE.
surface. Pull the trigger.
THE TOOL MUST CYCLE.
surface.
THE TOOL MUST NOT CYCLE.
THE TOOL MUST NOT CYCLE.
contact trip against the work surface.
THE TOOL MUST CYCLE.
work surface, then pull the trigger.
THE TOOL MUST CYCLE.
WARNING: Keep tool pointed in a safe direction when loading
WARNING: Never load nails with the contact trip or trigger
retaining clip.
