cecotec bolero DRESSCODE 7200 INVERTER Manual De Instrucciones página 70

ENGLISH
Note: If the brush is not clean, pull out the filter and wash it separately. Then, reconnect it and
turn on the tap.
Cleaning the detergent dispenser
Press down the arrow on the softener cover inside the dispenser drawer.
Lift the clip up and take out the softener cover and wash all grooves with water.
Replace the softener cover and push the drawer into position.
Pull out the dispenser drawer by pressing the A. Fig. 29.
Clean the dispenser drawer under running water. Fig. 30.
Clean inside the recess with an old toothbrush. Fig 31.
Insert the dispenser drawer. Fig. 32.
Warning: Do not use alcohol, solvents or chemical products to clean the washing machine.
Cleaning the drain pump filter
Warning:
Be careful with the hot water!
Allow detergent solution to cool down.
Unplug the machine to avoid electrical shock before washing.
The drain pump filter can filter the yarns and small foreign matters from the washing.
Clean the filter periodically to ensure proper operation of the washing machine.
Open the lower cover cap. Fig. 33.
Rotate 90 °C and pull out the emergency drain hose and take off the hose cap. Fig. 34.
When it is fully emptied, reset the drain hose. Fig. 35.
Open the filter by turning it counterclockwise. Fig. 36.
Remove dust, dirt and other substances or objects. Fig. 37.
Close the lower cover cap. Fig. 38.
Warning:
Make sure that the valve cap and emergency drain hose are reinstalled properly, cap plates
should be inserted aligned to the hole plates.
*Some machines don have emergency drain hose, so step 2 and step 3 can be skipped.
Rotate the lower cover cap directly for water to run into the basin.
When the appliance is in use and depending on the programme selected there can be hot
water in the pump. Never remove the pump cover during a wash cycle, always wait until the
appliance has finished the cycle and is empty.
When replacing the cover, ensure it is securely re-tightened.
70