Idiomas disponibles
Idiomas disponibles
English
b) If you choose to empty the drain through the
drain plug, please note the trajectory that the
oil will take when falling into the chassis of the
lawnmower, place a large container to catch all of
the oil before it spills on the ground.
We recommend that you put a big plastic covering
in the area in which you will change the oil so that
oil does not fall on the ground. Once the work area
is prepared, remove oil drain plug and slightly tilt the
lawnmower so that the oil comes out and falls into the
container.
Empty the engine oil into a suitable container so that
you can carry it to a proper clean point.
Insert the filled 0,65l of oil tube.
Wait 1 minute for the oil to completely go down to the
crankcase.
Clean the dipstick from the oil with a cloth.
Insert the rod and screw on the oil cap.
Unscrew the plug again and check the mark left by
oil on the dipstick. The mark left by the oil must be
between the minimum and maximum marks.
If the mark is below the minimum, add a little more oil
and recheck.
If the mark is above the maximum, you will have to
remove oil from the crankcase. To do this, tilt the
machine and let out a little oil (put a container at the
end of the tube to prevent oil spilling on the machine
or the ground).
8.2.3. CHECKING THE SPARK PLUG
When it comes to starting a machine, the most
common problems are produced by a dirty spark plug
or one in poor condition. Clean and check the spark
plug regularly. Check that the electrode gap is correct
(0.6 - 0.7 mm).
50/164
