Silca Easy Scan Plus Manual De Uso página 11

Easy Scan Plus
Note:
This func on responds only with Silca remote controls.
If remote controls by another manufacturer are used, the
Easy Scan Plus display will show:
If the remote control cannot be copied the Easy Scan Plus
display will show the following message:
IDENTIFICATION / COPY OF A QUARTZED REMOTE CONTROL
The "Iden fi ca on" and "Check Copy" func ons for quartzed remote controls is the same as that for fi xed
code ones.
Before star ng a copy check procedure, Easy Scan Plus requires the intensity of the signal from the copied
remote control to be tuned:
Open the remote control case (see remote control instruc-
ons).
Take the quartzed remote control up to the reading area (to
make contact see fi gure 1), hold down any bu on.
Use the ceramic screwdriver to slowly turn the antenna
adjus ng screw to achieve maximum band on the intensity
indicator on the display.
When the maximum value is reached, move the remote
control a li le farther away and repeat the opera on un l
the maximum visible on the display is reached.
Close the remote control case.
CHECK COPY FUNCTION
Use the bu ons on the side of the display to select "Check
Copy".
Press "ENTER" to con nue.
Take the original remote control up to the reading area (to
make contact see fi g.1) and press any bu on on the remote
control.
OTHER EASY SCAN PLUS FUNCTIONS
Copyright Silca S.p.A 2016
Copy check
NOT SILCA REMOTE
Verify again?
(ESC) NO
Identifi cation
Not copyable remote
(ESC) main menu
Antenna Tuning
0 | 50
Press remote button
(ESC) back
Main menu
Identifi cation
> Copy check
Frequency meter
Antenna Tuning
Options
(ENT) to continue
Copy check
Press any key
on original Remote
(ESC) main menu
English
(ENT) YES
433 MHz
| 100
(ENT) Next
11