Idiomas disponibles
Idiomas disponibles
Using the appliance
Mains operation
♦
Connect the power cable q to the mains
connection of the glue gun 0 (see fig . A) . Insert
the power plug into the socket . The control lamp
for the mains connection 2 lights up .
♦
Fold down the plastic stand 6 . Put down the
appliance .
♦
Push a glue stick into the feeder shaft 1 .
♦
Allow the appliance to heat up for about
5 minutes . The appliance is now ready for use .
Cordless operation
♦
Connect the power cable q to the mains
connection of the table station 3 . Insert the
power plug into the socket .
♦
Place the glue gun into the table station 4 .
The control lamp for the mains connection 2
lights up .
♦
Push a glue stick into the feeder shaft 1 .
♦
Allow the appliance to heat up for about
5 minutes . The appliance is now ready for use .
♦
Repeat the heating phase if the glue is still too
thick or viscous .
Gluing
♦
Pull the trigger 5 to control the flow of glue in
accordance with your requirements .
♦
Apply the glue in spots . For flexible materials,
such as textiles, apply the glue in zigzag lines .
♦
Press the two workpieces to be bonded together
immediately after applying the glue and hold
for about 30 seconds . The glued bond is ready
after about 5 minutes .
♦
During breaks in work, put the glue gun down
on the plastic stand 6 or replace it in the table
station 4 .
♦
Remove any glue residue after it has cooled
down with a sharp knife . Bonded joints can be
released by heating .
Switching the appliance off
♦
Unplug the appliance from the mains socket .
■
22
│
GB │ MT
Maintenance and cleaning
WARNING! ALWAYS REMOVE THE
POWER PLUG FROM THE POWER
SOCKET BEFORE CLEANING THE
APPLIANCE.
■
The glue gun is maintenance free .
■
Keep the appliance clean and dry at all times .
■
Never permit liquids to enter inside the appli-
ance . Use a cloth to clean the housing . Never
use petrol, solvents or cleansers which can
damage plastic .
Disposal
The packaging is made from environ-
mentally friendly material and can be
disposed of at your local recycling
plant .
Do not dispose of power tools
in your normal domestic waste!
As required by European Guideline
2012/19/EU, worn-out electrical
appliances must be collected separately and fed
into an environmentally compatible recycling
process .
Your local community or municipal authorities can
provide information on how to dispose of the
worn-out appliance .
Dispose of the packaging in an envi-
ronmentally friendly manner . Note
the labelling on the packaging and
separate the packaging material
components for disposal if necessary . The pack-
aging material is labelled with abbreviations (a)
and numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites .
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out product .
PHP 500 E3
