Idiomas disponibles
Idiomas disponibles
Installation
(*): Min. 6 in. (152 mm), Max. 8 in.
(203 mm)
STEP 4 Level the washer
26
English
Untitled-2 26
Untitled-2 26
A
*
A
3. Route the drain hose to the drain
system.
CAUTION
• If using a standpipe, make sure the
standpipe and drain hose connection is
not airtight.
• If using a standpipe, make sure the
drain hose is inserted at least 6 in.
(152 mm) but no more than 8 in.
(203 mm) into the standpipe.
4. Secure the drain hose with cable ties.
1. Slide the washer into position.
2. Open the lid of the washer, and then
pour water into the tub until the blades
of the pulsator on the bottom of the
washer are about half covered.
3. If the washer is level, the pulsator (A)
will be positioned at the center of the
tub as shown in the figure and the
water will appear level in the tub. That
is, the water will reach the same height
on all sides of the tub.
2022-06-28
2022-06-28
3:25:57
3:25:57
