English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum
Max. flow rate
04270xx5
04270xx0
Hole size in mounting surface
spout
valves
Max. depth of mounting surface
* Please know and follow all applicable local plumb-
ing codes when setting the temperature on the water
heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
This faucet requires ½" hot and cold
supply lines (not included).
• The drain is suitable for most, but not all, lavatory
sinks sold in the United States and Canada.
This unit meets or exceeds the
following:
• ASME A112.18.1/ CSA B125.1
• Section 116875 of the California
Health & Safety Code
• Listed by IAPMO for use in the US
and Canada
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
158°F (70° C)*
1.2 GPM (4.5 L/min)
1.5 GPM (5.7 L/min)
1⅜" (35 mm)
1¼" (32 mm)
1⅝" (40 mm)
• This drain is intended for use in a sink with an
overflow. If your sink does not have an overflow,
or if this drain is too small for the hole in your
sink, please refer to the instructions
included with the sink. Some sinks include
special drain installation instructions and/
or parts. Others require the use of a specialty
drain. Hansgrohe is not respnsible for the cost of
a specialty drain.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
