Idiomas disponibles
Idiomas disponibles
10.5
REPLACE THE CUTTING LINE
NOTE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.08 " (2 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into the
slot in the center rim of the spool. Make sure that the line
snaps into position in the slot.
3. With your finger between the lines, wind the lines equally
and tightly around the spool in the indicated direction.
4. Put the lines in the guide slots.
NOTE
English
5. Do not wind the lines beyond the edge of the spool.
10.6
REPLACE THE BUMP KNOB
1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Hold the bump knob (23) and pry it out with a metal rod
(not provided).
5. Put the new bump knob into the spool housing.
11
TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.
11.1
MOVE THE MACHINE
When you move the machine, you must:
•
Wear gloves.
•
Stop the machine.
•
Remove the battery pack and charge it.
•
Assemble the blade guard.
11.2
STORE THE MACHINE
•
Remove the battery pack from the machine.
11
WARNING
EN
