Idiomas disponibles
Idiomas disponibles
English
5) Keep all cutters the same length. (Fig. 47)
6) File enough to remove any damage to cutting
edges (side plate (62) and top plate (63)) of
cutter. (Fig. 48)
62
55
NOTE
Do not fi le or alter the tops of bumper drive links
(61). (Fig. 47).
Sharpening angles for sharpening
saw chain
1. Part Number
2. Pitch
0.025"
3. Depth Gauge Setting
4. Side Plate Filing Angle
85°
5. Top Plate Angle
6. File Guide Angle
100°
Replacement bar and chain combination
BAR NO.
MODEL
160 MLBK 041
NO.
180 MLBK 041
OREGON
200 PXBK 041
Maintenance schedule
Below you will fi nd some general maintenance
instructions. For further information please contact
Tanaka dealer.
18
61
Fig. 47
63
56
Fig. 48
95VPX/20BPX
0.325"
0.025"
85°
30°
100°
LENGTH-
CHAIN
TYPE
NO.
16"
95VPX-66
18"
95VPX-72
20"
20BPX-78
Daily maintenance
○ Clean the exterior of the unit.
○ Clean the chain oil fi lter port.
○ Clean the groove and oil fi lter port in the guide
bar.
○ Clean the side case of saw dust.
○ Check that the saw chain is sharp.
○ Check that the bar nuts are suffi ciently tightened.
○ Make sure that the chain transport guard is
undamaged and that it can be securely fi tted.
○ Check that nuts and screws are suffi ciently
tightened.
Especially inspect the bolt of muffl er and ensure
that they are properly tightened before starting
engine. Should any of the bolts be loose,
retighten them immediately. Failure to do so
could result in serious hazard.
○ Check the tip of the guide bar. Please exchange
it for the new one when it is worn out.
○ Check the band of chain brake. Please exchange
it for the new one when it is worn out.
○ Clean the air fi lter.
Weekly maintenance
○ Check the recoil starter, especially cord.
○ Clean the exterior of the spark plug.
○ Remove the spark plug and check the electrode
gap. Adjust it to 0.024" (0.6 mm) or change the
spark plug.
○ Clean the cooling fi ns on the cylinder and check
that the air intake at the recoil starter is not
clogged.
Monthly maintenance
○ Rinse the fuel tank with gasoline, and clean fuel
fi lter.
○ Clean chain oil fi lter.
○ Clean the exterior of the carburetor and the
space around it.
○ Clean the fan and the space around it.
○ Clean the muffl er of carbon.
NOTE
CKA
When ordering the parts to your nearest dealer,
45°
please use the item numbers showing on the
45°
parts breakdown section in this instruction.
48°
