Ferroli BLUEHELIX TECH RRT 34 C Instrucciones De Uso, Instalación Y Mantenimiento página 183

BLUEHELIX TECH RRT 34 C
Plate heat exchanger
Before carrying out the following instructions it is advisable to protect the room and the boiler's electrical box
A
against accidental water spillage.
3
2
• Isolate the boiler by operating the DHW inlet and system shut-off valves.
• Open a faucet to drain the domestic hot water.
• Rotate the box on the panel
• Drain the water in the boiler through the drain faucet (see *** 'System draining' on page 158 ***)
• Undo the screws "2"
• Move the plate heat exchanger back and slide it to the left.
• Remove the heat exchanger as shown in the figure
• When refitting the plate heat exchanger, make sure the arrows (indicating: HEATING) are pointing downwards.
Circulating pump
Before carrying out the following instructions it is advisable to protect the room and the boiler's electrical box
A
against accidental water spillage.
2
1
fig. 38
• Disconnect the power supply and turn off the gas cock ahead of the valve.
• Electrically disconnect the circulating pump, releasing the connections by raising the detail "1" of fig. 38.
• Drain the water in the boiler (see "System draining" on page 158).
• Unscrew and remove the circulating pump motor assembly (fig. 40)
EN
2
1
fig. 37- Plate-type exchanger replacement/maintenance
fig. 39
cod. 3541N270 - Rev. 02 - 11/2017
3
4
fig. 40
183