Idiomas disponibles
Idiomas disponibles
10.2
INSTALL THE TRIGGER HANDLE
8
7
9
1. Slide trigger handle (7) on the connecting tube (8).
2. Move trigger handle to desired location before fully
tightening. Use supplied knob (9) to tighten trigger
handle to the connecting tube.
3. Place the cord (10) in the cord retainer (11).
10.3
INSTALL THE BLOWER TUBE
c
12
a
13
1. Align either of the grooves (a) in tube (12) with the tabs
(b) on tube (8). Turn the tube (12) in the direction of the
arrow until both of the tabs slide into the lock positions
(c).
2. Connect the tube (13) to tube (12). For shorter tube
application, turn rear tube counterclockwise and move
tube to upper position (d).
English
10
11
8
b
12
d
10.4
ASSEMBLE THE TUBE ASSEMBLY
The tube assembly can be disconnected from the backpack
assembly.
1. Press the blower release button (14) and pull up to
disconnect the tube assembly from the backpack
assembly.
10.5
INSTALL THE BATTERY PACK
17
15
WARNING
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
•
Read and understand the instructions in the battery and
charger manual.
1. Unlock the latches (15) on both sides to release the dust
cover.
2. Remove the dust cover (16) to expose the battery
compartment.
3. Align the battery pack with the cavity in the backpack
housing.
4. Insert the battery pack into the backpack housing.
5. Push the battery pack into the backpack until it locks into
place. You will hear a click once it is locked into place.
6. Do not use force when inserting the battery pack. It
should slide into place and click.
7
EN
14
16
