RealFlame C11842LP Treviso Square Manual Del Propietário página 14

Ocultar thumbs Ver también para C11842LP Treviso Square:
Idiomas disponibles

Idiomas disponibles

Using the igniter
1. Read and understand all operating instructions
2. Burner control knob must be in the OFF position.
3. Connect propane (LP) cylinder (see previous pages).
4. Slowly open valve on LP gas cylinder.
5. Push and hold igniter button
6. While holding the igniter button with one hand, use
your other hand to push and turn the control knob
to the LIGHT position to light the burner.
7. Keep Burner Control Knob pressed in for 15-30 seconds after ignition.
8. If ignition does not occur in 30 seconds, turn control knob to the OFF position and turn
gas o at the source, wait 5 minutes until gas has cleared and repeat lighting procedure.
9. After lighting, rotate the Burner Control Knob counter clockwise to LOW setting.
Observe flame, make sure all burner ports are lit. Flame height should be no higher than
13 inches tall.
10. Adjust the flame to the desired height with the
control knob.
Using a Long Match or Lighter
1. Prior to lighting, use a shovel to move the filler
for access to the burner
2.
Wearing heat resistant gloves, position
the burning long match or burning butane
lighter near the side of the burner. DO NOT
lean over the fire pit while lighting!
3. Turn control knob counterclockwise to LIGHT.
4. Remove long match/long butane lighter.
5. After lighting, use a shovel and heat resistant
gloves to carefully move the filler back into
the proper position.
6.
After lighting, rotate the Burner Control Knob
counter clockwise to LOW setting.
Observe flame, make sure all burner ports are lit.
Flame height should be no higher than
13 inches tall.
7. Adjust the flame to the desired height with the
control knob.
!
WARNING
If burner flame goes out during operation,
immediately turn the control knob OFF and let the
gas clear a minimum of 5 minutes before attempting
to re-light the fire pit.
Please refer to the trouble shooting pages for
additional support, beginning on page 18.
LIGHTING INSTRUCTIONS
before lighting.
!
WARNING
When using this method to light
your fire pit use heat resistant
gloves and follow the step by step
instructions. Failure to do so could
result in severe injury.
14
8-13"
20.3 - 30.5 cm
Control Knob
OFF
PUSH
IN
HI
loading