Idiomas disponibles
Idiomas disponibles
NOTE
The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that diff er from those on your own Nailer.
MAINTENANCE AND INSPECTION
<Nailer>
Read section titled "SAFETY" (pages 5 – 12).
● Remove battery and all remaining fasteners
from Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Inspecting the magazine
1 Remove battery.
2 Clean the magazine. Remove dust and wooden chips
which may have accumulated in the magazine.
CAUTION
● Check that the nail feeder slides smoothly by
pulling it with fi nger.
If not smooth, nails can be driven at an irregular
angle and hurt someone.
2. Storing
○ Do not store the Nailer, and battery in a cold weather
environment.
Keep them in a warm area.
○ When not in use, the Nailer, and battery should be
stored in a warm and dry place.
Keep it out of reach of children.
MAINTENANCE
WARNING
5 Close guide plate and latch.
NOTE
● In case of frequent jam, contact a metabo HPT
authorized service center.
3. WARNING LABEL
Change the WARNING LABEL if missing or
damaged.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
4. Maintenance chart (See page 30)
5. Operator troubleshooting (See page 30 – 31)
6. Disposal of the exhausted battery
Do not dispose of the exhausted battery. The
battery must explode if it is incinerated. The
product that you have purchased contains a
rechargeable battery. The battery is recyclable.
At the end of it's useful life, under various state
and local laws, it may be illegal to dispose of this
battery into the municipal waste stream. Check
with your local solid waste offi cials for details
in your area for recycling options or proper
disposal.
English
Warning label
WARNING
29
