Idiomas disponibles
Idiomas disponibles
English
NOTE
Operations 3 and 4 should be done within
2 seconds of each other. If more than 2 seconds
pass after 3, the Nailer will not work properly. If this
happens, retry from 3.
Nailing operation
indicator (Light in blue)
3
Push lever
4
(2) Continuous operation (Push lever fi re)
Using CONTACT ACTUATION MECHANISM
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Do not press the nailer against the wood
with excessive force.
2) Separate the nailer from the wood as it
recoils after nailing.
1 Set the nailing operation switch to CONTACT
ACTUATION
MECHANISM
indicator is blink in blue.)
(to set to CONTACT ACTUATION MECHANISM).
(Set the switching device to the nailing operation
indicator blink in blue completely as shown in the
diagram. Otherwise, it will not operate properly.)
2 Pull the trigger with the Nailer off the workpiece.
3 Depress the push lever against the workpiece to drive
a nail.
4 Move the Nailer along the workpiece with a bouncing
motion.
Each depression of the push lever will drive a nail.
As soon as the desired number of nails have been driven,
remove fi nger from the trigger.
26
Nailing
operation
switch
Trigger
WARNING
(Nailing
operation
NOTE
Operations 2 and 3 should be done within
2 seconds of each other. If more than 2 seconds
pass after 2, the Nailer will not work properly. If this
happens, retry from 2.
Nailing operation
indicator (blink in blue)
Previously pull the trigger
4
2
● Keep your fi nger off the trigger except during
nailing operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. This metabo HPT nailer may
bounce from the recoil of driving a nail and
unwanted subsequent nail may be driven,
possibly causing injury.
NOTE
● If all warnings and instructions are followed,
safe operation is possible with all two systems:
FULL SEQUENTIAL ACTUATION MECHANISM,
CONTACT ACTUATION MECHANISM.
● Always handle nails and package carefully. If nails
are dropped, collating bond may be broken, which
will cause mis-feeding and jamming.
● After nailing:
1) remove battery from the Nailer;
2) remove all nails from the Nailer;
Nailing operation
switch
WARNING
