Idiomas disponibles
Idiomas disponibles
● When the pilot lamp fl ikers rapidly in red (at
0.2–second intervals), check for and take out
any foreign objects in the charger's battery
installation hole. If there are no foreign objects,
it is probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.
BEFORE OPERATION
Read section titled "SAFETY" (pages 5 – 12).
Make sure of the followings before operation.
PREPARING THE BATTERY
Read section titled "SAFETY, IMPORTANT SAFETY
INSTRUCTIONS FOR BATTERY CHARGER" (page 9).
You must charge the battery before use.
The charging method of battery is shown in page 17 - 19.
HOW TO OPERATE OPERATION
PANEL
Power
switch
Power indicator
Battery indicator
switch
Battery indicator
(1) Power switch ON
Under the condition of "Power switch OFF", push
and hold on Power switch more than 1 second, then
power indicator lights in Green.
NOTE
● Do not press the push lever and/or pull the trigger
during the process of turning the power switch ON.
Doing so will prevent the power switch from turning
ON.
Nailing operation
indicator
Nailing
operation switch
OFF
Light in green
ON
(2) Power switch OFF
Under the condition of "Power switch ON", push
and hold on Power switch more than 1 second, then
power indicator goes off .
Under the condition of "Power switch ON", functions
below are active.
(3) Select Nailing operation mode
(Full sequential actuation / Contact actuation)
After power switch turn ON, always set in Full
sequential actuation mode as initial. (Nailing
operation indicator light in blue.)
To change nailing operation mode, push Nailing
operation switch once. Every pushing, mode will
change between "Full sequential" and "Contact".
Lighting (Blue):
FULL SEQUENTIAL ACTUATION MECHANISM,
Blinking (Blue):
CONTACT ACTUATION MECHANISM
(4) Check Remaining battery level
When pressing the battery indicator switch, the
battery indicator shows Remaining battery level by
status of LED lamp as below.
English
Light in blue
Blink in blue
19
