Idiomas disponibles
Idiomas disponibles
wArning:
contact the blade guards or produce poor quality cuts in the workpiece.
To Change the Blade
1. unplug the saw
2. Lift up the lower blade guard (3). Loosen the Phillips screw
(1) on the blade bolt cover (2).
3. Lift up the blade bolt cover (2) to expose the blade bolt.
4. Depress the spindle lock (7) and rotate the blade until the
spindle locks.
5. using the Wrench (4) provided, loosen the blade bolt (5) by
turning it clockwise. Remove the blade bolt.
6. Remove the outer blade flange (6).
7. Remove the old blade from the saw.
note:
A blade washer may be use for the blade with arbor
hole bigger than 5/8 inch.
8. Mount the new blade carefully onto the spindle, being sure
that the directional arrow on the blade surface matches the
arrow on the upper blade guard.
9. Replace the outer blade flange and the blade bolt.
10. Depress and hold down the spindle lock while tightening the
blade locking bolt securely with the provided wrench in a
counterclockwise direction.
11. Lower the lower blade guard and the blade bolt cover to its
original position.
12. Retighten the Phillips screw securing the blade bolt cover.
13. Be sure the spindle lock has released and blade rotates freely
before plugging in the tool and making a cut.
LASER GUIDE (FIG 10,11)
wArning:
into the beam, aperture, or into a reflection from a
mirror-like surface.
wArning:
is emitted from the rear guard aperture. use
of controls or adjustments, or performance of
procedures other than those specified herein may
result in hazardous laser light exposure.
wArning:
module.
wArning:
or performance of procedures other than those
specified herein may result in hazardous radiation
exposure.
Your miter saw is equipped with a battery powered laser. The
laser battery compartment (3) is located at the back of the
saw. See figure 10. Two AAA batteries (provided) are required to
operate the laser. The Laser ON/Off switch (4) is located on the
battery compartment.
The laser alignment was made at the factory and is set for the center of the Blade or Draw line. Adjustment may
be required prior to initial use due to the effects of shipping and handling. You also have the ability to adjust the
line projected by the laser to your liking. You may wish for the laser to be to right or left of the blade, or straight
on a drawn cut line. Where you ultimately decide to align the laser in relation to the saw blade's cutting path will
determine how you align the cut line.
do not use thin kerf blades with deep gullets which may deflect and
Laser light – do not stare
Avoid exposure – laser light
do not disassemble the laser
uSe of controls or adjustments
FIG 8
FIG 9
5
FIG 10
3
FIG 11
1
2
4
6
4
2
11
