Idiomas disponibles
Idiomas disponibles
12. Maintenance and cleaning
Danger!
Disconnect the mains plug before carrying out any
cleaning work.
Note: The welding machine must be serviced and
overhauled regularly to ensure proper operation and
compliance with safety requirements. Improper and
incorrect operation may result in failure and damage
to the device.
• Before carrying out any cleaning work on the
welding device, pull the mains cable 8 out of the
socket so that the device is safely disconnected from
the power supply circuit.
• Clean the outside of the welding device and its
accessories regularly. Remove dirt and dust using
air, a cleaning rag or a brush.
Note: The following maintenance work shall be carried
out only by qualified specialists.
• Current regulator, earthing device, internal wiring,
the welding torch coupling device and adjustment
screws should be serviced regularly. Retighten
loose screws and replace rusty screws.
• Regularly check the insulation resistances of the
welding device. Use the appropriate measuring
device for this purpose.
• In the event of a defect or if it is necessary to replace
parts of the device, please contact the appropriate
specialist personnel.
The device has no further internal parts that require
maintenance.
Service information
With this product, it is necessary to note that the
following parts are subject to natural or usage-related
wear, or that the following parts are required as
consumables.
Wearing parts*: Earth clamp, current nozzle, burner
nozzle
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
36 | GB
13. Storage
Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The
optimum storage temperature lies between 5 and 30
˚C. Store the power tool in its original packaging. Cover
the power tool to protect it from dust or moisture. Store
the operating manual with the power tool.
14. Disposal and recycling
The device is supplied in packaging to avoid
transport damages. This packaging is raw
material and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made
of different materials, such as metals and
plastics. Take defective components to special waste
disposal sites. Check with your specialist dealer or
municipal administration!
Old devices must not be disposed of with
household waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised
collection point for the recycling of old electrical and
electronic devices. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly
disposing of this product, you are also contributing to
the effective use of natural resources. You can obtain
information on collection points for waste equipment
from your municipal administration, public waste
disposal authority, an authorised body for the disposal
of waste electrical and electronic equipment or your
waste disposal company.
www.scheppach.com
